Complete Excavation Works
If your existing driveway, patio area or course remains in poor problem or if you have no existing tough surface area or are looking to expand your exterior area, we will embark on the required preparation benefit a resin bound system.

Initially, we excavate down to an ideal deepness to get rid of the existing surface area.
Then, we install a below base of kind 3 granular or comparable (175mm).
Next, a base of 10mm open rated porous tarmac is laid, approximately 60mm. This enables the water to drain via.


Finally, your very own option of a resin bound accumulation is laid at a minimum deepness of 18mm to complete your green exterior location.
We either mount block paving setts to serve as a bordering kerb or a concrete kerb. One of the most preferred option without a doubt is a Marshall Tegula 160mm x 120mm.

Our preferred tarmac is 10mm open graded tarmac, as it is permeable and allows any kind of surface water to drain pipes back into the below base. Concrete, on the other hand, is non-porous and also for that reason is not eco-friendly.

If you need a bigger driveway, a resin bound surface supplies an affordable service as we can set up the resin in addition to your existing driveway, leaving just the prolonged area looking for a new structure. The resulting appearance will be seamless. For comparison, if you were aiming to extend your block led driveway, your existing surface would certainly need to be pulled up in order to achieve a totally blended look. This would certainly not be an economical service.